We got an old salvaged bookshelf from ReStore a couple years ago. It was missing (or never had) a finished end panel. Thinking that it would either a.) be a really long time before we would make a nice paneled trim piece for it, or b.) it didn’t deserve a nice paneled trim piece, I decided to clad it in an old sign (picked up for $1 at ReStore).
What we did:
I wanted to mock up the design so we measured the panel and made a cropping template with paper. Positioned the paper template on top of the sign to get an idea of best cropping.
Marked and cut the sign with a circular saw, with straight edge, clamped to a table. I don’t have a picture of this, but it is the same idea as what we did in a previous project.
Sanded the edges with fine sandpaper to finish off the edges.
Pre-drilled the nail holes in the plywood sign, because it was thin and we were nailing so close to the edge. Nailed it into place. Could have used screws, but liked the look of the nails better.
All done, good enough for now – maybe someday I’ll get around to putting something more refined on there, but then again, probably not!
See more of Heidi’s artwork at Old Stuff. New Stories.